Uploaded by roxipoxi SEND US YOUR BEST FIXES!
How to make a steel ruler anti-slip
Put Sugru on the back of a steel ruler to make it more difficult for it to slip when you are cutting.
Kit
- 1 single-use foil pack of Sugru
- 1 steel ruler
- Cling film
Step 1
Open a pack and mould Sugru into ten equally sized balls.
Step 2
Place each Sugru ball on the ruler.
Step 3
You can use the markings on the ruler to make sure the balls are evenly spread. In this case, I put Sugru on the inches side because I measure in centimetres.
Step 4
Push each Sugru ball into the ruler.
Step 5
Turn over the ruler and push it against a flat surface to make the Sugru layer even. Use cling film to avoid sticking and protect the surface.
Step 6
Wait 24 hours for Sugru to cure...
Step 7
... and start cutting. Remember to be careful when using a knife.