Make your own tablet wall mount
Loads of our users have been using Sugru Mouldable Glue to make tablet mounts in their kitchen so we thought we would give it a go ourselves. This is super handy for browsing through recipes or getting some light entertainment whilst cooking.
Sugru is perfect for this project because it bonds to most materials and doesn't require any nails or screws - super useful if your kitchen is tiled. Its rubbery qualities make it really easy to place the tablet. PLUS Sugru is removable from non porous surfaces - great if you rent rather than own your property.
- 2 single-use packs of Sugru
- Cling film
- Washing up liquid
Knead together your 2 single-use packs of Sugru. Take a small amount for the top clip (about 1/3 of a pack) and divide the remaining Sugru in two for the bottom shelves. We've done some fun colour mixing here. If you want to create a custom colour for your kitchen then check out the page: How to mix Sugru to make custom colours.
Start by wrapping your iPad in cling film. Mark on the wall two points underneath the iPad about a quarter of the way in on both sides and one point at the top in the middle.
Take the two larger pieces of Sugru and press into the bottom points. Shape them into shelves just thicker than the tablet.
Use the remaining smaller piece to build your top clip. This should be slightly longer so that it can wrap over the top of the tablet. This is what secures the tablet in place.
Rub a small amount of washing up liquid along the top and bottom of the wrapped tablet.
Now to position your tablet in place. Start by pressing the bottom side into the bottom shelves of Sugru. Then lift up the top clip and place the tablet underneath it.
Slightly press the tops of the shelves around the base of the tablet. Do not wrap them round too much as gravity will make them droop. These shelves are just for support, it is the top clip that secures the tablet in place.
Fold the top clip over the top and front of the tablet. It only needs to wrap about a centimetre over the front of the tablet to hold it in place.
Remove the tablet by sliding it out of the side, the soapy water should make this possible. Once removed press the top clip in tight to the wall (but do not make contact with the wall or any other Sugru). This will help it keep the tablet tight and secure against the wall once it has set.
Sugru sets in 12-24 hours, but depending on the thickness of the application, for load-bearing projects, allow up to 48 hours for Sugru to fully set.
Once set, just slide your tablet into place and get cooking in style!