Improve and protect your speakers with Sugru feet
Sugru feet for beats
Audiophiles, here is a little known fact about Sugru Mouldable Glue: moulding this wonder material into cones for your speakers will isolate sound vibrations, meaning you get nicer tunes and fewer complaints from the neighbours. Not just technically impressive, they look pretty darn good too.
You can easily mould these clever little cones by hand, and they'll totally work. But for the perfectionists among us, we’ve designed a 3D printed mould so you can produce precision cones yourself.
Download the 3D file for free from MakerBot's Thingiverse, the world's largest 3D printing community, and print it at home or find your local 3D printer at 3D Hubs.

Using your mould with Sugru

Step 1 — Coat the mould
Paint a light coat of soapy water (that’s just a drop of dish soap in water) onto the inside of the mould and shake off the excess.

Step 2 — Press in your Sugru
Roll half of a single-use pack of Sugru into a sausage and press into the mould.

Step 3 - Press and twist
Press the Sugru slowly and firmly onto your speaker and twist gently from side to side.

Step 4 - Remove excess Sugru
Sugru will extrude through the hole in the top of the mould and out the sides. Remove this excess Sugru.

Step 5 - Remove the mould
Gently lift off the mould to reveal a perfectly formed speaker foot. Clean any more excess with a dry tissue and repeat for all 4 feet per speaker.

Step 6 - Let it set
Leave the Sugru to set for 12-24 hours and then enjoy your new and improved speakers!
Buy some Sugru
We ship worldwide