Make a multimeter easier to use

I've added a few pieces of sugru to the back of my multimeter to cut down on the number of hands I need.

I needed to monitor the amperage while I made adjustments to a small laser engraver. I had a hard time keeping the probes on the test locations while turning the adjustment screw. I ordered an 8 pack and used them as shown in the two photos. The red and black holds the probes at an angle to allow a wider range of usage. The white was added because I made the red and black a little too thin on the first attempt. The blue was added to hold a single probe while I move the red around to various test points.

I used a piece of the wrapper foil to keep a split in all three clamps until they cured.

Great product!